I am using an Olimex sam7s256 board. I tried to get it up and running in linux
(Ubuntu). I was able to successfully install GCC and binutils. I installed
SAM-BA for linux from the atmel site. I was able to get the USB port for
connection as specified in the SAM-BA manual (.dev/ttyUSB0). But when I try to
use the GUI and 'connect' there is no response. I though that there is
a connection failure, so when I presses the reset button in the board, I get a
message "Failed to initialize FLASH accesses". No matter how long I wait before
pressing the reset button, I am not getting any SAM-BA window as given by the
SAM-Ba tutorials.
can any one one help me out in this? I did the 'tst' jumper set,
reconnect the board for 10 s, disconnect and 'tst' jumper reset,
reconnect before opening SAM-BA. Any help will be greatly appreciated. I am
stuck. It is the same for both SAM-BA 2.9 and 2.8.