Memfault State of IoT Report

Power Failure on Target CPU

Started by George December 30, 2009
Dear everyone

My emulator and target board run properly before today, however, when I
open my develop environment and debug my program again it appeared the error
information as follow:

1) Power Failure on Target CPU: Error 0x00001020/-1145 Error during:
Execution, Target,

2) Unrecoverable emulation error Sequence ID: 16 Error Code: -1145
Error Class: 0x00001020
Failed to remove the debug state from the target before disconnecting.
There may still be breakpoint opcodes embedded in program memory. It is
recommended that you reset the emulator before you connect and reload your
program before you continue debugging.

Please give me some suggestion or correct answer

Thank you very much


Best regards


Memfault State of IoT Report