>>>You can take a look at the detailed >>>datasheet and the ADC section for details, if 10 bit is sufficient.Ah, I think I missed the "detailed" part... yea, that datasheet is loads more helpful! I got the SPS rate and the settling time when switching channels :)>Do you have previous experience with microcontroller projects?I have absolutely no prior experience with microcontroller projects :(>I don't know much about analog circuits, but if you think it is thepower>supply, you can test it with a battery. I think you should see somethingon>a scope, if you try to measure some muscle contraction, otherwise youare>out of luck with a simple single ended ADC of a microcontroller.Yea, testing with a battery is probably a good idea. My signal is... pretty good at the moment, there is just a small sinusoidal signal superimposed on the muscle signal... I'll have to consult my professor when she gets back if she has any recommendations... not sure if I could try adding another small range filter to eliminate the 60Hz before recording or something... shall see.>A good specification is important, but sometime you have to do some >research on your own to fill missing details in the specification.Good point. I'll try doing some more reading up on what others have already done.>This one has 64 MBit and costs $3 for larger quantities. That's strange, >because you'll get 2 GBytes USB memory sticks in single quantities formuch>less than $10, even for a single unit. I wonder what flash chips theyuse.>Comparing the prices, the 64 MBit chip is about a factor of 100 to >expensive. Maybe it's cheaper to buy an USB memory stick, break it and >desolder the flash :-)I'd probably prefer to just pay a few extra bucks rather than mess around taking apart a memory stick ^_^;; Thanks for all the help :) Sounds like I've got some more things to research.. Tyler
Searching SBC/DSP board/microcontroller; 4ADC/1kHz/USB Host
Started by ●May 7, 2009
Reply by ●May 25, 20092009-05-25
Reply by ●May 26, 20092009-05-26
Yoreki wrote:> I have absolutely no prior experience with microcontroller projects :(Then this would be a hard project for your first microcontroller project. But the good news is that you'll learn a lot, if you manage to finish it.> Yea, testing with a battery is probably a good idea. My signal is... > pretty good at the moment, there is just a small sinusoidal signal > superimposed on the muscle signal... I'll have to consult my professor when > she gets back if she has any recommendations... not sure if I could try > adding another small range filter to eliminate the 60Hz before recording or > something... shall see.You could try a notch filter. -- Frank Buss, fb@frank-buss.de http://www.frank-buss.de, http://www.it4-systems.de