Atmel AVR, too slow encoder tics counting

On Fri, 7 May 2004 14:20:41 +0200, "Alexander Peter"
<apeter@musicandsales.com> wrote:

>Umpa schrieb:
>>> How fast do you want to go?
>> 
>> 10 kHz would be enough.
>> But, above two people have said that
>> my ATmega16 works with 1MHz
>> frequency, and I need to attach
>> cristal. I think, it solves my problem.
>
>You can set up your internal RC to 8 or 16MHz by progamming the corrseponding fuses. Look at the datasheet!
>
>Alexander

Internal RC can be set to 1MHz (Defult), 2,4 and 8 MHz. If you want
higher than that you need to use one of the other clock options.
With the 8MHz clock, you can probably handle up to 38.4kbaud.


Regards
   Anton Erasmus