I am trying to send the data to UART1 in LP2148. Given below is the code. But the data displayed is only some junk (mainly ???? is displayed). I am not able to makeout the problem. The terminal software is configured at 9600 baud. pclk is 15 MHz. Here is the code: #include <lpc214x.h> //Includes LPC2148 register definitions #define Fosc 12000000 #define Fcclk (Fosc * 5) #define Fcco (Fcclk * 4) #define Fpclk (Fcclk / 4) #define UART_BPS 9600 //Set Baud Rate here const unsigned char SEND_STRING[] = "Hello. This is a test programnSend any character from terminal to continuen"; const unsigned char SEND_STRING1[] = "Test Passedn"; void Init_UART1(void) //This function setups UART1 { unsigned int Baud16; U1LCR = 0x83; // DLAB = 1 Baud16 = (Fpclk / 16) / UART_BPS; U1DLM = Baud16 / 256; U1DLL = Baud16 % 256; U1LCR = 0x03; } void UART1_SendByte(unsigned char data) //A function to send a byte on UART1 { U1THR = data; while( (U1LSR&0x40)==0 ); } void UART1_SendStr(const unsigned char *str) //A function to send a string on UART1 { while(1) { if( *str == ' UART1_SendByte(*str++); } } int main(void) { PINSEL0 = 0x00050000; // Enable UART1 Rx and Tx pins PINSEL1 = 0x00000000; PINSEL2 = 0x00000000; Init_UART1(); UART1_SendStr(SEND_STRING); while((U1LSR&0x01)==0); UART1_SendStr(SEND_STRING1); while(1) { } // return(0); } --------------------------------------- Posted through http://www.EmbeddedRelated.com
Unable to send data to host on UART1 in LPC2148
Started by ●April 7, 2015