Hello All. I have two distant locations connected with 3-wire cable - "+", "-" and "common". Voltage 24V DC can occasionally appear between "+" or "-" and "common". I have to install Ethernet communication through this cable. Modification of special Netgear "Ethernet over Power line" switch solves the problem but I have to disassemble the switch, cut and reconnect some wires. It's too difficult to rebuilt about 200 Netgear switches. Maybe somebody knows the device, which does it 'as is'? Thanks.
Ethernet over servo motor control lines
Started by ●May 5, 2008
Reply by ●May 5, 20082008-05-05
On Mon, 05 May 2008 09:24:59 -0700, baranovus wrote:> Hello All. > I have two distant locations connected with 3-wire cable - "+", "-" and > "common". Voltage 24V DC can occasionally appear between "+" or "-" and > "common". I have to install Ethernet communication through this cable. > Modification of special Netgear "Ethernet over Power line" switch > solves the problem but I have to disassemble the switch, cut and > reconnect some wires. > It's too difficult to rebuilt about 200 Netgear switches. Maybe > somebody knows the device, which does it 'as is'? Thanks.Try this question on sci.engr.control -- there's a lot of industrial control guys on that group, one of whom may know the answer. -- Tim Wescott Control systems and communications consulting http://www.wescottdesign.com Need to learn how to apply control theory in your embedded system? "Applied Control Theory for Embedded Systems" by Tim Wescott Elsevier/Newnes, http://www.wescottdesign.com/actfes/actfes.html