Hi all,
i m trying to connect arm7tdmi-s development board with H-JTAG,its showing
connected but when i try to program it ,it shows "can't halt target and
make it in debug state" .I changed so many thing but unsuccessful.Fro serial
flash utility it is not even detecting the board.when trying to blank
check,"operation failed:failed to auto baud-step 1" comes..My LPT & COM port
both r working.please help me out.and where can i find LPC2000 PHILIPS FLASH
UTILITY.i heard its workin..
LPC2000 PHILIPS FLASH UTILITY
Started by ●May 31, 2009
Reply by ●May 31, 20092009-05-31
> i m trying to connect arm7tdmi-s development board
with H-JTAG,its
> showing connected but when i try to program it ,it shows "can't halt
> target and make it in debug state" .I changed so many thing but
> unsuccessful.Fro serial flash utility it is not even detecting the
> board.when trying to blank check,"operation failed:failed to auto
> baud-step 1" comes..My LPT & COM port both r working.please help me
> out.and where can i find LPC2000 PHILIPS FLASH UTILITY.i heard its
> workin..
http://www.flashmagictool.com/
Start with a low baudrate like 9600... because you have not written which crystal and which processor your are using...
You know, you need to control P0.14 and Reset-Line ?
Regards,
Martin
> showing connected but when i try to program it ,it shows "can't halt
> target and make it in debug state" .I changed so many thing but
> unsuccessful.Fro serial flash utility it is not even detecting the
> board.when trying to blank check,"operation failed:failed to auto
> baud-step 1" comes..My LPT & COM port both r working.please help me
> out.and where can i find LPC2000 PHILIPS FLASH UTILITY.i heard its
> workin..
http://www.flashmagictool.com/
Start with a low baudrate like 9600... because you have not written which crystal and which processor your are using...
You know, you need to control P0.14 and Reset-Line ?
Regards,
Martin
Reply by ●May 31, 20092009-05-31