Hi, I'm using IAR workbench with an olimex lpc2468 board, I was trying to
write the .hex file using the flashMagic, I was able to download it before
without problem, but now when I try to use the flashmagic tool. i get the
message failed to autobaud ! when I try to download the program with JTAG, usin
IAR I can download it with success but, I run steps in debugging mode but it
seems that code is not executed (my LCD p.e doesnt Init !!)
Can you help please ?
is it possible to overwirte the ISP code ??
Best Regards
Zakaria Nakrachi
LPC2000 FlashMargic - autobaud failed !! Urgent please help
Started by ●November 5, 2009
Reply by ●November 5, 20092009-11-05
--- In l..., "zanakca" wrote:
>
> Hi, I'm using IAR workbench with an olimex lpc2468 board, I was
> trying to write the .hex file using the flashMagic, I was able to
> download it before without problem, but now when I try to use the
> flashmagic tool. i get the message failed to autobaud !
1. Go to:
http://www.flashmagictool.com/resources.html
2. Download the document:
"App Note 4 What to do if ISP does not work"
--
Chris Burrows
CFB Software
Armaide: LPC2xxx Development System
http://www.armaide.com
>
> Hi, I'm using IAR workbench with an olimex lpc2468 board, I was
> trying to write the .hex file using the flashMagic, I was able to
> download it before without problem, but now when I try to use the
> flashmagic tool. i get the message failed to autobaud !
1. Go to:
http://www.flashmagictool.com/resources.html
2. Download the document:
"App Note 4 What to do if ISP does not work"
--
Chris Burrows
CFB Software
Armaide: LPC2xxx Development System
http://www.armaide.com