Hi everyone,
I'm currently having problems with the MAC_MAC1 register on a board
similar to the MCB2300. I'm trying to run the easyweb keil example but it
crashes when MAC_MAC1 = MAC1_PASS_ALL;
I'm debbugin with the ulink2 but when I run that line it crashes with
error "Could not stop arm device! Please check the JTAG cable".
Has anyone solved this problem?
Thanks in advance
Best regards
Gustavo
Problem with MAC - Ethernet
Started by ●June 7, 2010
Reply by ●June 7, 20102010-06-07
Probably, it has something to do with the ENET_TX_CLK
or ENET_RX_CLK setting:
http://www.keil.com/support/docs/3358.htm
and check how the MAC is connected to the PHY on the board,
if the connection is wrong, you willl have a H/W fault when
you access the MAC1 register.
best,
Tom
--- In l..., Gustavo Alonso wrote:
>
> Hi everyone,
>
> I'm currently having problems with the MAC_MAC1 register on a board similar to the MCB2300. I'm trying to run the easyweb keil example but it crashes when MAC_MAC1 = MAC1_PASS_ALL;
> I'm debbugin with the ulink2 but when I run that line it crashes with error "Could not stop arm device! Please check the JTAG cable".
> Has anyone solved this problem?
>
> Thanks in advance
> Best regards
> Gustavo
>
or ENET_RX_CLK setting:
http://www.keil.com/support/docs/3358.htm
and check how the MAC is connected to the PHY on the board,
if the connection is wrong, you willl have a H/W fault when
you access the MAC1 register.
best,
Tom
--- In l..., Gustavo Alonso wrote:
>
> Hi everyone,
>
> I'm currently having problems with the MAC_MAC1 register on a board similar to the MCB2300. I'm trying to run the easyweb keil example but it crashes when MAC_MAC1 = MAC1_PASS_ALL;
> I'm debbugin with the ulink2 but when I run that line it crashes with error "Could not stop arm device! Please check the JTAG cable".
> Has anyone solved this problem?
>
> Thanks in advance
> Best regards
> Gustavo
>