nobodyo@nobo... wrote:
> Hi,
>
>
>>>and how much time does
>>>it take to detect the transition (at 1.5 V) with a comparator and a
>>>comparator-ISR?
>>
>>The device isn't rated to operate at 1.5V.
>
>
> The device can operate with an input edge voltage of 1.5 V. This is within
the specification.
> Which input is faster for detecting a relative slow H->L transition
(edge) at that voltage: Digital input or Comparator input?
>
> Regards
>
> Rolf F.
oN THE SURFACE IT SHOULDN'T MAKE ANY DIFFERENCE, however I'd go for
the
digital, since it will probably toggle at a lower threshold anyway.
I know English isn't your first langfuage, but you need to be a bit
clearer, your last post read as if you were looking at responses based
on supply voltage NOT input voltage.
Al
flash erasing brownouts
Started by ●September 13, 2003
Reply by ●September 27, 20032003-09-27
Reply by ●September 27, 20032003-09-27
This book is out of print but I'll mention it anyway because I see it
used
around a lot. Not a textbook, but an invaluable compendium of hardware
design rules of thumb:
"Circuit Designer's Companion" by Tim Williams.
Basically reads like the lab notebook of a really smart hardware designer
who's been around the block a bunch of times. A great hardware design
quick reference. Mostly overviews of each topic, but covers a practical
minimum of every major gotcha, including bypassing, power and ground
routing, high frequency design, emc, high-current design, etc. on a
practical, hands-dirty, need-to-know-maths-only level.
If you ever see a copy, buy it.
--Bruce
> > There are design rules for this kind of thing
that good
> > text books will teach you about.
>
> You know a good one? ;-)
Reply by ●September 27, 20032003-09-27
This one is alsog good: "Art of Electronics" by Hill
and Horowitz.
-Sumukh
--- Bruce Cannon <brucecannon@bruc...> wrote:
> This book is out of print but I'll mention it
anyway
> because I see it used
> around a lot. Not a textbook, but an invaluable
> compendium of hardware
> design rules of thumb:
>
> "Circuit Designer's Companion" by Tim Williams.
>
> Basically reads like the lab notebook of a really
> smart hardware designer
> who's been around the block a bunch of times. A
> great hardware design
> quick reference. Mostly overviews of each topic,
> but covers a practical
> minimum of every major gotcha, including bypassing,
> power and ground
> routing, high frequency design, emc, high-current
> design, etc. on a
> practical, hands-dirty, need-to-know-maths-only
> level.
>
> If you ever see a copy, buy it.
>
> --Bruce
>
> > > There are design rules for this kind of thing
> that good
> > > text books will teach you about.
> >
> > You know a good one? ;-)
>
>
>
__________________________________