I am quite new with the development kit for RCM 3000. Is there any
sample programs readily available in Dynamic C to be use such that it
can allow transfer of data received through the RS232 port and
transmit through the RJ45 Lan port? I am currently working on a
project which involve the receiving of data and transmitting od data
through the lan port. The data is in the form of a continuous stream
of audio signals. Could I just use the sample programs directly
without making any changes?
Transfer Data using Serial Port RS232 and Ethernet Port RJ45
Started by ●December 29, 2003
Reply by ●December 29, 20032003-12-29
Message
How is the data coming in and how do you want it to go out?
Typical 8 bit ascii coming in and Telnet outgoing? Check out the
vserial.lib stuff.
-----Original Message-----I am quite new with the development kit for RCM 3000. Is there any
From: John123 [mailto:b...@yahoo.com]
Sent: Sunday, December 28, 2003 11:18 PM
To: r...@yahoogroups.com
Subject: [rabbit-semi] Transfer Data using Serial Port RS232 and Ethernet Port RJ45
sample programs readily available in Dynamic C to be use such that it
can allow transfer of data received through the RS232 port and
transmit through the RJ45 Lan port? I am currently working on a
project which involve the receiving of data and transmitting od data
through the lan port. The data is in the form of a continuous stream
of audio signals. Could I just use the sample programs directly
without making any changes?
Yahoo! Groups Links
To
