Query for accessing 512k flash memory of RCM 3200

Hi, First of all I want to clear that I have right core. As you mentioned I checked all settings regarding it. It all are perfectly ok. As you mentioned I had done it bur problem remain same. I want to use 512k Flash. Pls give me more feedback on this so I can solve my problem as soon as possible. Sumeet --- In r...@yahoogroups.com, Scott Henion wrote: > > Scott Morris wrote: > > It sounds to me like you have the wrong core and options selected in the > > "Project Options->Targetless->Board Selection" field of Dynamic C. You > > can change the RAM options under the Specify Parameters tab and then > > define your own target if the target is not defined as you claim. My DC > > (8.31) says the 3200 is only 256K RAM. It has 512K FLASH. > > > The board selection is not really complete.The 3200 has 512k fast RAM, > 256k BBRAM and 512k Flash. > > The compile mode effects amount of RAM: > > Compile to flash: 512k code + 256k RAM, 512k fast RAM not used. > Compile to RAM: 256k code+data max. (fast RAM not used.) > Compile to FLash, Run in RAM: code+data in 512k fast RAM. Reast of fast > RAM and 256k BBRAM available for xmem data. > > Compile to flash, run in RAM is really the only mode you want to use, it > is the only one that maps all of RAM in the memory map and runs code 32% > faster than the other modes. > > ------ > | Scott G. Henion| shenion@... | > | Consultant | Stone Mountain, GA | > | SHDesigns | PGP Key 0xE98DDC48 | > | http://www.shdesigns.org | > ------ > today's fortune > If you notice that a person is deceiving you, they must not be > deceiving you very well. > Yahoo! Groups Links Start a New Thread