hello all,
I have made a customised version of AT91RM9200-EK_Rev_A01 board from atmel.I
have davicom DM9161AE connected as PHY in RMII mode and pulse engineering pe1012
as pulse transformer. when I boot linux on this board, linux boots properly, it
detects DM9161AE ( I have confirmed it by disconnecting 50MHz clock to 9161AE
and then it gives mesaage PHY not detected). But after booting it gives message
" eth0: link down". I have connected the other end of ethernet cable to a hub.
The hub also does not detect the link ( link detect led not glowing). I have
checked the cable by conncting it to a PC and with same HUB, in this case Hub
detects link (link detect LED glowing), and file transfer also happens between
two PCs. I mean the Hub and the cable are OK.
Also if I do self pinging (ping to the IP assigned to this board, throuh
console) it is OK, but if i ping any other IP, ping fails.
has anybody faced this type of problem.
Any solutions/ suggestion are most welcome.
thanks in advance.