Hi, I'm using MC68HC912B32 EVB, and trying to use POD mode with Serial Device Interface(SDI) from Motorola to free the SCI port for other purpose. I connect the 6pin header to the BDM out, set jumper J1 to A, J2 to B as said in User Manual, turn on power, do communication settings, however, my MCUez debugger doesn't seem to detect the board. Anyone experienced in this pls give me a hint how to go, thanks alot! VT |
|
MC68HC912B32 EVB with Motorola SDI
Started by ●January 7, 2004
Reply by ●January 7, 20042004-01-07
Hello VT I don't know that particular EVB, but in general, POD mode means you are using this MCU to program a second EVB. And the BDM-out only connects to BDM-in on the other MCU board, not to a serial port. The EVB in POD mode does the translation between the PC's serial port and the target EVB's BDM-in. best regards Robert > > Hi, > I'm using MC68HC912B32 EVB, and trying to use POD mode with Serial > Device Interface(SDI) from Motorola to free the SCI port for other > purpose. > I connect the 6pin header to the BDM out, set jumper J1 to A, J2 to B > as said in User Manual, turn on power, do communication settings, > however, my MCUez debugger doesn't seem to detect the board. > Anyone experienced in this pls give me a hint how to go, thanks alot! > VT |