I have a little box named Arium RP256 In the upper side of the box is a small idc male connector called IN and a db female connector named OUT. In the lower side are six connectors for the emulated roms. I begin to rev-eng the pcb to see the connections. What I like to do is put it to work connected to a PC parallel port, does anyone have an electric diagram, timing, source or binary code to use it? Also someone know what type of equipent use it? I guess a philips dev-sys. bye Tia John
info for ARIUM RP256 eprom emulator
Started by ●October 4, 2004
Reply by ●October 6, 20042004-10-06
delo <myipopo@libero.it> wrote in message news:Gs68d.23508$H11.736027@twister1.libero.it...> I have a little box named Arium RP256Rom Pod 256. There is also an RP-016> In the upper side of the box is a small idc male connector called IN and a > db female connector named OUT. > In the lower side are six connectors for the emulated roms.It can emulate 1 to 4 ROMs; data widths of 8, 16 and 32 bits; up to 32 (?) address bits.> I begin to rev-eng the pcb to see the connections. > What I like to do is put it to work connected to a PC parallel port, > does anyone have an electric diagram, timing, source or binary code > to use it?It is intended as a peripheral to another piece of equipment.> Also someone know what type of equipent use it? > I guess a philips dev-sys.It is used with an Arium Logic Analyzer -- like an ML4400. The device has long since been obsolete. You'll have very little luck getting info from the manufacturer (currently DBA "American Arium"). --don